ALLCOAT Epoxy Line Marking Paint Anti Slip

A heavy duty anti slip epoxy ester fast-drying, chemical resistant paint for line and lane marking

Epoxy Line Marking Paint Anti Slip

Heavy Duty Line Marking

1litre – £34.80


A heavy duty anti slip epoxy ester fast-drying, chemical resistant paint for line and lane marking on weathered blacktop, brick, paving, wood and particularly concrete. The addition of Aluminium Oxide enables the anti slip properties of this product.

Typical Uses

  • Car parks
  • Roads
  • Runways
  • Factory floor demarcation
SKU: Single Pack Epoxy Line marker plus Aluminium Oxide. Categories: , , , , .

Surface Preparation

Ensure that surface to be coated is dry and free from oil, dust, road salts and other contaminations before application is commenced. Check compatibility with newly applied asphalt surfaces, synthetic all-weathered sports surfaces and thermoplastic line marking materials before over-coating this type of substrate. Do not apply at temperatures below 5°C or where condensing conditions are expected.


Stir thoroughly before use. Apply by airless or conventional spray, preferably by lining machine. Do not thin the coating as line
definition and film build might be affected. If thinning is essential, a maximum of 10% addition of ALLCOAT Thinner R30 may be added.

The included Aluminium Oxide should be added to the wet film surface, immediately after application. If added reflectance is required then Ballotini beads should be purchased from the Aggregates section of the website and applied at a rate of 400g per m².

Small areas can be applied by brush, using a well loaded brush but do not attempt to brush-out the coating, or alternatively use ALLCOAT Superline.

Overcoating: Should a second coat be required, this should be applied after a minimum drying time of 1 hour has elapsed.

Clean-up: ALLCOAT Thinner R30


1 litre, 5 litres


Black, Blue, Green, Red, White, Yellow

Appearance of dried film


Volume solids


Dry film thickness

Typical 150 microns

Theoretical coverage

3.34m² per litre (up to 44 metres of 75mm width line per litre at 150 microns DFT)

Drying time - touch dry

10 minutes @ 20°C

Drying time - film dry

15 minutes @ 20°C


1 hour minimum

Shelf life

2 years in unopened containers, when stored under cover in good storage conditions


Under cover with temperature range of 5°C to 32°C

There are no reviews yet, would you like to submit yours?

Be the first to review “Epoxy Line Marking Paint Anti Slip”


Related Products

You may also like…