5kg – £80.00
Allcoat Eopxy Floor Seal is a solvent free, low viscosity epoxy resin penetrating sealer and binder for strengthening and restoring poorly compacted or low strength concrete and screeds.
- Water damaged concrete (when dried)
- Car parks
- Bridges / footbridges
- Sports stadiums
- Pre-fabricated cast concrete structures
Features & Benefits
- Penetrates and protects concrete from cracks
- Seals existing cracks
- Increases compressive strength of concrete by up to 40%
- Restores colours
- Creates watertight seal – excellent for use on bridges, footbridges and car parks to prevent water ingress
- Dust repellent
- Can be used on vertical surfaces
- Simple and easy to apply
Preparatory work and installation in accordance with good flooring practices.
Pour the mixed material over the prepared screed immediately and spread using a squeegee or roller so as to ensure even penetration of the screed. Continue applying the Allcoat Epoxy Floor Seal until no more resin is absorbed into the substrate. Fine aggregate should be scattered over the surface to provide a mechanical key for further toppings. Alternatively, apply one coat of Allcoat Epoxy Prime and sand blind once the Allcoat Epoxy Floor Seal has been allowed to cure for at least 6 hours.
The ambient temperature of the works area should be a minimum of 15°C during the application and curing period, if not adhered to this can affect the performance of the system.
Materials and substrate temperature must be above 15°C.
Allcoat Epoxy Floor Seal is supplied in 5kg and 10kg units.
Coverage depends upon surface porosity and depth of screed. As a guide, a 50 mm screed may require 3 – 5 kg of Allcoat Epoxy Floor seal per square metre. A test area will provide more accurate coverage.
10kg, 5 kg
1-5m² per Kg (depending upon surface absorption)
DIN 53 217: 0.97 g/cm³
8-10 Hours @ 20°C
Min 12 months in original containers