5litres – £55.60
A single-pack polyurethane coating typically used as a hard-wearing matt coating for concrete floors.
Previously Painted Floors: Ensure existing coating is firm and sound with good adhesion. Thoroughly clean with detergent water, rinse and dry-off.
New Concrete: Concrete should be clean, dry and free of surface laitence’. Power-floated floors or floors with surface laitence should be prepared by abrasive cleaning or acid etching. Any sealer coat using ALLCOAT Concrete Floor Paint Matt, thinned 30% with ALLCOAT Thinner R1. Allow to dry overnight. Apply one or two coats of unthinned ALLCOAT Concrete Floor Paint Matt.
Apply by brush or roller. (Large areas can be sprayed but adequate ventilation would be required to remove over-spray and solvent vapours.)
ALLCOAT Thinner R1
20 litres, 5 litres
Beige, Light Grey, Mid Blue, Mid Green, Mid Grey, Tile Red
|Appearance of dried film||
50% (may vary with colour)
Typically 8m² per litre depending on film thickness applied and surface profile, absorption, etc.
|Drying time - touch dry||
3 hours at 20°C
|Drying time - film dry||
6 hours at 20°C
Overnight (dry for foot traffic after overnight drying)
2 years in unopened containers, when stored under cover in good storage conditions
Under cover with temperature range of 5°C to 32°C