20kg – £87.44
ALLCOAT Self Levelling Epoxy is a rapid setting, solvent -free self-levelling, epoxy resin seamless floor coating, combining outstanding wearing properties with chemical resistance and pleasing decorative properties.
ALLCOAT Self Levelling Epoxy has good resistance to spillage and splash contact to a wide range of liquids at ambient temperatures for up to 24 hours.
ALLCOAT Self Levelling Epoxy is designed for use in environments where jointed finishes (tile, sheet etc) are not acceptable and short programme times are required. Additional decorative effects can be produced by the introduction of coloured plastic flakes, lightly scattered on the surface and subsequently sealed.
ALLCOAT Self Levelling Epoxy is available in a range of colours.
- Rapid cure times giving an early return to service
- Easily cleaned
- Chemical resistant
- Seamless and hard wearing
- Hygienic – does not support fungus or bacterial growth
- Solvent – free
- Available in a range of attractive colours
ALLCOAT Self Levelling Epoxy offers significant advantages over conventional epoxy systems, due to its easy application and rapid return to service. It provides a surface that is both durable and easy to maintain with conventional cleaning materials and methods. It is ideal for use in food processing, laboratories, clean rooms, operating theatres and industrial environments. (Note: Do not steam clean or use hot water above 60 ºC).
All surfaces should be dry, free from oil, grease dust and chemicals etc. and free of laitance. The surface should be first diamond ground, scarified, scabbled or shot blasted.
N.B. All surfaces must be sound and provide a good mechanical key.
All areas to be treated with ALLCOAT Self Levelling Epoxy should first be primed with ALLCOAT Epoxy Damp Proofer, where no DPM is present, at a coverage rate of 3-4 sq.m. per kg. and allowed to dry. Two coats of primer may be necessary on very worn, pitted or porous surfaces.
Mixing and application
Priming should be undertaken in accordance with the relevant product data sheets and materials laid off to ensure a uniform sealed surface. On to the primed surface fix stop ends or tapes to define the areas to be coated. Mark any movement joints etc. that are required to be cut after the floor is cured.
Premix the resin and hardener and then add the aggregate to the mix smoothly. Do not mix more material than can be efficiently used. When thoroughly mixed together, pour the mix evenly over the appropriate area to be covered. Spread the mix evenly over the area with a notched trowel or notched squeegee to the appropriate thickness, and after 5-10 minutes roll with a spiked roller to achieve an even smooth surface and remove entrapped air etc.
N.B. Spiked rolling must be undertaken 5-10 minutes after trowelling. Do not re-roll later.
Blue, Dark Grey, Green, Light Grey, Red, Yellow
0.5mm – 5mm
7.3 m² for 28 kg unit
15 mins @ 20ºC
|Curing time (touch dry)||
|Curing time (foot traffic)||
|Curing time (full traffic)||
|Curing time (full chemical)||
1 year in unopened containers