ALLCOAT Epoxy Line Marking Paint

A heavy duty epoxy fast-drying, chemical resistant paint for line and lane marking

Epoxy Line Marking Paint

Line Marking paint

2.5litre – £46.00

Description

A heavy duty epoxy chemical resistant paint for line and lane marking on weathered blacktop, brick, paving, wood and particularly concrete.

Typical Uses

  • Car parks
  • Roads
  • Runways
  • Factory floor demarcation

 

Advantages
  • Ease of application
  • Hygienic and easy to clean
  • Excellent adhesion to concrete
  • Hard wearing
  • Excellent chemical resistance
  • High Build Finish

 

 

SKU: Single Pack Epoxy Line marker. Categories: , , , , .
5 for 10% off

Surface Preparation

To be assured of maximum adhesion and properties from Allcoat’s resin products the correct surface preparation is essential. The concrete substrate must be a minimum of 28 days old and the residual moisture content must be a maximum of 75% RH.

The substrate should be sound with a minimum compressive strength of 25 N/mm2 and a minimum pull-off strength of 1.5 N/ mm2. The surface must be clean, dry and free of contaminants such as dirt, oil, grease, coatings and surface treatments. If in doubt, apply a test area ”rst. Concrete substrates should be mechanically prepared using vacuum enclosed abrasive blast cleaning or diamond grinding equipment to remove laitance and previous surface treatments leaving an open textured surface.

Weak concrete must be removed and repaired using recommended Allcoat products.

Application

Epoxy Line Marking Paint should be applied onto an existing epoxy resin coating within 36 to 48 hours of the !nished coat, if this period is exceeded mechanical abrasion of the coating should be carried out.

Apply by brush, short piled roller at a nominal rate of 0.25 kg/m2. After a minimum of 12 hours and before a maximum of 36 hours, apply a second coat at the same rate. Should a non-slip !nish be required, then broadcast an appropriate aggregate immediately after the !rst coat. Brush off excess aggregate once the material has cured, prior to applying the second coat.

The ambient temperature of the works area should be a minimum of 15°C during the application and curing period, if not adhered to this can affect the colour and appearance of the system.

Materials and substrate temperature must be above 10°C.

Priming

Prime the prepared surfaces using Allcoat Epoxy Primer applying the material at a nominal rate of 5 m2 per Kg. Allow the primer to cure for a minimum of eighteen hours @ 20°C . NOTE: If the surface is porous it may be necessary to apply subsequent coats of the priming material until the substrate is fully sealed

Mixing

Pour the contents of the Curing Agent into the Base container and thoroughly mix by mechanical means until a uniform colour and consistency is achieved. Do not mix by hand.

Overcoating

Should a second coat be required, this should be applied after a minimum drying time of 12 hour has elapsed.

Clean-up

ALLCOAT Thinner R30

Size

2.5kg, 5 kg

Colour

Black, Blue, Green, Red, White, Yellow

Theoretical coverage

A 2.5 kg pack is sufficient to coat approximately 10m2 floor area per coat. Coverage is dependant on surface profile, texture, porosity and substrate temperature.

Drying time - touch dry

3 hours @ 20°C

Overcoat

12 hour minimum

Shelf life

2 years in unopened containers, when stored under cover in good storage conditions

Storage

Under cover with temperature range of 5°C to 32°C

ALLCOAT Epoxy Line Marking PAint TDS   ALLCOAT Epoxy Line Marking PAint TDS

ALLCOAT Epoxy Line Marking Paint COSHH   ALLCOAT Epoxy Line Marking Paint COSHH

There are no reviews yet, would you like to submit yours?

Be the first to review “Epoxy Line Marking Paint”

*



Related Products

You may also like…