ALLCOAT Fast Cure Epoxy Primer

ALLCOAT Fast Cure Epoxy Primer has been developed for use in conjunction with ALLCOAT Epoxy Mortards for concrete repair operations.

Fast Cure Epoxy Primer

PU Primer

2.5kg – £31.92

ALLCOAT Fast Cure Epoxy Primer has been developed for use in conjunction with ALLCOAT Epoxy Mortards for concrete repair operations, and with ALLCOAT Epoxy Self Levellers and Screed for seamless Epoxy floor coatings. The product exhibits outstanding adhesion to concrete and other surfaces.
ALLCOAT Fast Cure Epoxy Primer is supplied as a two packsystem, comprising of pre weighed amounts of Base and Curing Agent components.

Typical Uses
As a primer for concrete prior to application of ALLCOAT Epoxy Mortar and ALLCOAT Epoxy Self Leveller. As an adhesive for bonding new to old concrete e.g.resin bonding new floor coatings to old concrete. As a protective treatment to exposed steel re-enforcementduring concrete repair.

Advantages
• Solvent free, low odour
• Excellent adhesion
• Impervious to water
• Low viscosity, easily applied
• Applies to damp surfaces
• Good chemical resistance

SKU: Fast Cure Epoxy Primer. Categories: , .

Mixing
Pour the full contents of the Curing Agent container into the Base container and mix thoroughly, preferably by mechanical means until a uniform colour and appearance is achieved.

Surface Preparation
A) Concrete surfaces shall be a minimum of 21 days old and/or the residual moisture content shall be below 6% . Ensure that the concrete is clean and free from dust, laitance, grease, oil, curing compound, existing paint finishes, etc. Suitable mechanical treatment such as vacuum grit blasting or mechanical scabbing are recommended to ensure the removal of contaminants and to provide a mechanical ‘key’ for the ALLCOAT Fast Cure Epoxy Primer.
B) Steel reinforcement shall be abraded, wire-brushed to remove all traces of rust. Priming should immediately follow preparation to obviate the possibility of flash rusting.

Application Techniques
Apply by brush, roller or airless spray to the prepared surface at a nominal rate of 0.15 to 0.30 Kg/m2. Make sure that the surface is thoroughly wetted out. Allow the primer to “tack up” for a minimum of 10 minutes prior to the application of subsequent treatments. Please refer to the product data sheet, as appropriate.
Note: in thin section the primer will remain ‘open’ for 45 minutes @ 20°C, within which time subsequent application should be carried out. Should this period be exceed then the surface must be reprimed prior to continuing.

Size

2.5kg, 5 kg

ALLCOAT Fast Cure Epoxy Primer TDS   ALLCOAT Fast Cure Epoxy Primer TDS

There are no reviews yet, would you like to submit yours?

Be the first to review “Fast Cure Epoxy Primer”

*



Related Products

You may also like…