5litres – £158.33
ALLCOAT Chemical Resistant Coating Anti Slip is a high grade, 2 pack, hard wearing epoxy anti-slip floor coating designed for maximum chemical resistance which is also light, fast and flexible. It is ideal where a seamless finish is required. ALLCOAT Chemical Resistant Coating Anti Slip has good resistance to impact abrasion and trafficking. The system is resistant to high temperatures up to 150°C.
Slight discolouration may occur at extreme temperatures.
Features & Benefits
- Maximum chemical resistance
- Rapid set properties – touch dry in just 2 hours, fully cured in 16 hours
- Good abrasion and impact resistance
- Aluminium oxide grit to provide a hard-wearing anti slip finish
- Easy cleaning, including removal of graffiti
- Light and fast installation – usually just one coat required
- Resistant to thermal shock & hot water
- Hygienic – does not support fungus or bacterial growth
- Attractive range of colours available
- Food preparation and manufacturing areas
- Chemical plants
- Aircraft hangers
- Vehicle maintenance bays
- Any areas where a long lasting, easily cleaned, high chemical resistance finish is essential
All surfaces to be coated with any grade of ALLCOAT Chemical Resistant Coating Anti Slip should be dry, clean and free from laitance, oil, grease or other contaminants. Ideally concrete surfaces should be vacuum shotblasted or mechanically abraded to both clean and open the surface to provide a good mechanical key. The separate base and hardener components must be thoroughly mixed together before application.
One or two coats of ALLCOAT Chemical Resistant Coating Anti Slip can be applied with a roller or brush. Slip resistance can be achieved by specifying a three coat system. The first coat of ALLCOAT Chemical Resistant Coating Rapid Set being followed by an additional coat of ALLCOAT Chemical Resistant Coating Anti Slip, lightly scattered with anti-slip aggregates whilst still wet, at a rate of 50/100 gms per sq.m. When dry a second ALLCOAT Chemical Resistant Coating Anti Slip coat can be applied.
ALLCOAT Chemical Resistant Coating Anti Slip coatings can be cleaned with water, or with ALLCOAT Industrial Floor Cleaner or other good quality detergent or just brushed out. ALLCOAT Chemical Resistant Coating Anti Slip coated floors should not be subject to hot water above 60ºC or steam cleaning.
ALLCOAT Chemical Resistant Coating Anti Slip products are formulated from materials which are designed to achieve the highest levels of performance as safely as possible. However specific components require proper handling and suitable equipment. This information is given in the relevant safety data sheets. In all cases spillage’s or skin contamination should be cleared as soon as possible by dry wiping the affected area and then thoroughly washing with soap and water.
ALLCOAT Chemical Resistant Coating Anti Slip has excellent resistance to fuels, oils, lubricants, solvents, alkalis, salts and some acids.
Chemical spillages should always be wiped up as quickly as possible and not allowed to evaporate. For further information, please consult our technical department.
In order to achieve the best results from this product, it is recommended that the product be used only when temperatures in excess of 10ºC are present with good ventilation.
Variations in temperature and humidity during the cure period can significantly affect the rate of drying and surface finish.
Blue, Dark Grey, Mid Green, Mid Grey, Tile Red
5m² per L per coat
|Dry film thickness||
125 microns at a coverage rate of 5m² per L
40 minutes at 20°C
|Touch dry time||
2 hours at 20°C
|Full Cured Time||
16 hours at 20°C
|Full chemical resistance||
16 hours at 20°C
2 years at ambient temperature