10Kg – £169.32
ALLCOAT Anti Slip Car Park Paint Quick Set is a 2 component, high build solvent free unpigmented polyurethane binder for surface dressing with aggregates to create non slip textured floor finishes that cures in 3 hours. ALLCOAT Anti Slip Car Park Paint Quick Set can be used in interior or exterior situations on a variety of substrates to provide high water resistant anti slip finishes. You need to choose a finish by purchasing an aggregate of your choice from the aggregates section. Maximum aggregate size 1-3mm.
Features & Benefits
- Excellent slip resistant finish
- Extremely hard wearing
- Can be decorative through using coloured aggregates
- High bond strength
- Will cure at temperatures down to 5°C
- Theme parks
- Public pathways
- Public concourse areas
- Loading bays
- Walkways around buildings and factories
- Demarcation of non slip areas
To acheive the best performance from ALLCOAT Anti Slip Car Park Paint Quick Set the correct surface preparation is essential. Substrates must be clean, sound, dry and free of surface laitance with a minimum strength of 25N/mm². All surfaces must be prepared by vacuum blasting or mechanical abrasion.
All surfaces to be treated with ALLCOAT Anti Slip Car Park Paint Quick Set should be clean and free from loose particles, oil and grease. Surfaces should be mechanically abraded to provide a good mechanical key.
Non porous substrates require thorough preparation but do not require priming.
Steel decking must be clean sound and free from rust, and primed with ALLCOAT QD Primer.
ALLCOAT Anti Slip Car Park Paint Quick Set is supplied as pre-weighed resins, splitting units is not recommended.
ALLCOAT Anti Slip Car Park Paint Quick Set should be applied at the required rate as soon after mixing as possible. (Delay can result in variation in surface finish, colour and add to application problems)
Mix the the base resins prior to mixing for a minimum of 1 minute. Apply with trowel or pinrake to an average 1.3mm thickness and spike roller to remove air and aid levelling. Immediately apply your aggregate, by broadcasting onto the wet Anti Slip Car Park Paint Quick Set resin base at a typical rate of 1.3kg per m². Different aggregate types will provide varying degrees of slip resistance. Maximum aggregate size 1-3mm.
Typical hard wearing aggregates would be – bauxite, granite, aluminium oxide, silicon carbide. NB. ALLCOAT Anti Slip Car Park Paint Quick Set is supplied as a resin system, the aggregate for surface dressing must be ordered separately and 2 – 4 kg per m² is recommended depending on size.
10kg, 20kg, 40kg
|Application - Curing Time||
3 hours @ 20°C
|Pack make up||
2 x resin
12 months ( base, hardener & aggregate)
10 kg will cover approx 8m² @ 1.3mm
10 minutes @ 20°C (from mixing)
4 hours @ 20°C
2 – 3mm
Method BS7976 pt1-3 2002: Dry > 65, low slip potential; Wet > 34, low slip potential
Up to 65°C