ALLCOAT WB Line Marking Paint

A heavy duty water based very fast-drying for line and lane marking on weathered blacktop, brick, paving, wood and particularly concrete.

Water-Based Line Marking Paint

DSCF0022

5litres – £68.64

Description
A heavy duty water based very fast-drying for line and lane marking on weathered blacktop, brick, paving, wood and particularly concrete.

Typical Uses

Car parks
Roads
Runways
Factory floor demarcation

Coating Type: Water-borne Acrylic.

Typical Uses: Fast drying paint for line and lane marking on concrete, blacktop, brick, paving and wood. Typical uses include car parks, roads, runways and factory floor demarcation.

Colours Available: White, yellow.

Appearance Of Dried Film: Matt.

Volume Solids: 58%

Specific Gravity: White 1.54 kg/litre Yellow 1.60 kg/litre

  • VOC Content: 122g per litre PG6/23 (97)
  • White: 53g VOC: 717g solids per litre PG6/23 (04)
  • Yellow: 55g VOC: 795g solids per litre PG6/23 (04)

Dry Film Thickness: Typical: 150 microns.

Theoretical Coverage: 3.9M² per litre (Up to 52 m of 75mm width line per litre at 150μ dft)

Drying Time At 20°C: Touch Dry: 5 minutes.
(Will vary with temperature, Firm Dry: 15 minutes. air movement etc.) Overcoat: 1 hour minimum

Packaging: 5, 20 litre containers.

Shelf Life: 2 years or longer in unopened containers when stored under cover in
good storage conditions.

Storage: Under cover within temperature range of 5°C to 32°C. Protect from
frost at all times

Surface Preparation: Ensure that the surface to be coated is dry and free from oil, dust, road salts and other contaminants before application is commenced. Check compatibility with synthetic all-weather sports surfaces and thermoplastic line marking materials before over-coating this type of substrate. Do not apply at temperatures below 5°C or where rain, snow or frost is expected.

Application:
Stir thoroughly before use. Apply by airless or conventional line marking equipment, do not thin the coating as line definition and film build might be affected. Ballotini beads may be added to the wet film surface, at the time of application, if added reflectance is required. A ballotini application rate of 400g perM² is recommended. Small area’s can be applied by brush, use a well loaded brush but do not attempt to brush out the coating.
Keep containers tightly sealed when not in use, the material will solidify if lids are not replaced. Clean equipment immediately after use with clean water.

Overcoating: Should a second coat be required, this should be applied after a
Minimum drying time of 1 hour has elapsed.

Clean-Up: Immediately with water & detergent

Size

20 litres, 5 litres

Colour

White, Yellow

There are no reviews yet, would you like to submit yours?

Be the first to review “Water-Based Line Marking Paint”

*



Related Products

You may also like…